material
1. Heavy anti-static desktop (thickness: 50mm)
2. Light anti-static desktop (thickness: 30mm)
3. Stainless steel table (thickness: 30, 50mm)
4. Carbon steel table (thickness: 30, 50mm)
principle
The anti-static workbench table is generally made of the surface material and conductive substrate by the anti-static melamine high pressure decorative laminate (commonly known as the anti-static voltage film fire prevention board). The conductive substrate is generally conductive particle board or graphite type composite board, which has the overall anti-static property. Static electricity can be directed directly to the earth by antistatic surface or ground line. [1]
merit
Humanized design, accord with ergonomic principle, comfortable and beautiful, improve production efficiency
Modular design, a variety of accessories can be in any combination, and it is interchangeable
Standardized design can customize the products you need according to different requirements
High quality desk panel, choose anti - static fire prevention board, have double - face integral antistatic, fire - proof, wear-resisting and so on
The support adopts the steel structure optimization design, and the selection of high quality cold rolled steel plate production, strong and durable
The metal surface is processed by pickling and phosphating, the high quality antistatic powder high pressure electrostatic spraying, flat and beautiful
Overall anti-static, eliminate the threat of potential static to the product radically [2] [2]
testing
The test of point resistance on the surface of the table should meet the national electronic industry standard SJ/T10694-2006. When testing the electrostatic leakage resistance of the workbench, one electrode is in good contact with the pad, and the other electrode (clamp) is connected to the grounding wire (or wrist band socket) of the workbench.
installation
1. Determine the size of the static radio pad according to the requirements of work. Use alcohol to thoroughly clean the bottom surface and top surface and components of the pad.
2. Lay foil on the surface of the anti-static radio. The aluminum foil is only allowed to be connected at the folding place. The knobs can be replaced by other nuts from the positive pressure of the anti-static radio pad, so that the electric contact can be guaranteed through the pads and foil straps.
3. Lay the prepared static static radio pads on the countertop. The area of anti-static floor mat should be determined according to the activity scope of the operator. Place the worktable on the antistatic mat.
4, anti-static grounding safety workbench, using cross-sectional area not less than 2 m ㎡ stranded copper cord or cable to prevent static radio pad and floor mat series 1 m respectively Ω resistor connected to ground wire configuration system. It is best to check for use after installation.